In the hydraulic pipe bender before working on the necessary to the hydraulic bending machine working parameters related settings, otherwise it can not realize the normal working environment of hydraulic pipe bender. To be clear is to set the parameters of hydraulic pipe bender environment. Note that the use of hydraulic pipe bender design and piping to avoid large arcs, arbitrary curves, composite bends and more than 180. Arc.
The size of the tube bending radius of the hydraulic pipe bender with appropriate bending radius determines the size of the resistance of the catheter during bending. Generally speaking, the diameter of large bending radius is small, bending prone to wrinkle and skidding phenomenon, bending quality is difficult to guarantee, Hydraulic Pipe Bending Machine so the general choice of bending die R value of pipe diameter of 2 3 times times as good.
At present, the connection between the hydraulic oil pump of the motor and the hydraulic pipe Bender does not need to rely on the flange to connect, through this small improvement design, not only the cost of waste control to save, later, we found that without the need for flange connection, the motor and the pump between the transmission smoother and noise also has a great improvement, because the axis of the connection shaft to connect the motor shaft directly, so not only improve the efficiency, but also increase the torque, Make hydraulic pipe bender and automatic hydraulic bending machine and hydraulic cutting machine, metal circular saw machine and liquid compressor pipe machine, Hydraulic Pipe Bending Machine such as the overall processing efficiency of the machine tool.
According to the specified shear plate thickness, adjust the hydraulic pipe bender scissors gap. It is not allowed to cut 2 kinds of sheets with different specifications and materials at the same time; The shearing sheet requires the surface to be flat and is not allowed to cut the narrower sheet material that cannot be compacted.
The operator of the hydraulic pipe Bender shall keep at least 200mm away from the scissors mouth and leave the clamping device. The protective fence placed on the trigger does not block the operator's eyes and does not see the cut. The waste produced after the operation angular, the author should be removed in time to prevent stab wounds and cut.
The clearance between the blades shall be adjusted according to the thickness of the sheet, but not greater than 1/30 of the plate. The knife plate should be fastened securely, on the upper and lower side of the board to maintain parallel, after the application of the manual test, Hydraulic Pipe Bending Machine in order to avoid accidents.