The function of the CNC pipe bending machine is the plastic forming of the pipe.
CNC pipe bending machine is mainly used for electric power construction, public railway construction, boiler, bridge, ship, furniture, decoration and other aspects of pipeline laying and construction, with more features, reasonable structure, simple operation, easy to move, fast installation and so on.
In addition to the machine with the elbow function, CNC Pipe Bending Machine but also the cylinder as a hydraulic jack to use, relative to the NC pipe equipment in terms of cheap, easy to use features, in the domestic CNC pipe mill market dominate the product position.
CNC bending machine can be a kind of bending radius (single mode) or two bending radius (double mold) winding bending in the cold state, widely used in automobile, CNC Pipe Bending Machine air conditioning and other industries of various pipe and wire bending.
CNC pipe bending machine features:
1, the motor drive the bending arm, the speed of movement, and at the same time to obtain rapid acceleration and rapid deceleration, and high torque
2, in the pressure, pressure boost system and the center line radius adjustment system using a sophisticated, heavy-duty linear rolling bearings
3, the car with direct drive rack and pinion and servo motor, CNC Pipe Bending Machine to the system provides a high precision and high reliability
4, automatic positioning of the self-calibration pressure, can be quickly set
5, three-station: can be multi-curvature, multi-diameter, CNC Pipe Bending Machine mixed curved and rectangular multi-side processing
6, semi-automatic or automatic feeding station
7, position control of the pipe booster system can be applied to small radius and complex elbow elbow application
8, power to replace the mold, so that the mold is simple and efficient replacement
How to maintain and maintain CNC bending machine
1, in the cleaning of the NC pipe fuel tank, to clean the pump into the oil filter.
2, the equipment began to use after 1 to 2 months, cleaning the tank and filter a hydraulic box.
3, such as the discovery of forward and retreat retreat failure, CNC Pipe Bending Machine first check whether the solenoid valve action such as solenoid valve normal operation, and then check the sequence valve, relief valve or one-way unloading valve impurity stuck phenomenon. (This phenomenon is generally easy to occur when the device is in use). If the phenomenon of stuck, open with gasoline or diesel cleaning, re-installed can be.
4, the hydraulic pump station parts are equipped with oil-resistant rubber seals, such as seal damage, oil spills, should be replaced.
5, check the parts of the fasteners, so that in a tight state.